Siemens SINAMICS G120 - r9409 Number of parameters to be saved; Qty par to save; r9451[0...29] Units changeover adapted parameters; Unit_chngov par; r9463 Actual macro; Actual macro; p9484 BICO interconnections search signal source; BICO S

To Next Page

To Previous Page

SINAMICS G120 Control Units CU240B-2/CU240E-2

List Manual (LH11), 01/2016, A5E33839529

403

2 Parameters

2.2 List of parameters

Description: Displays the number of modified parameters and those that have still not be saved for this drive object.

Dependency: Refer to: p0971

Notice: Inherent to the system, the list of the parameters to be backed up is empty after the following actions:

- Download

- Warm restart

- Factory setting

In these cases, a new parameter backup must be initiated, which is then the starting point for the list of modified

parameters.

Note: The modified parameters that still need to be saved are internally listed in r9410 ... r9419.

Description: Displays the parameters whose parameter would have to be changed during a units changeover.

Dependency: Refer to: F07088

Description: Displays the set valid macro.

Note: A value of 0 is displayed if a parameter set by a macro is changed.

Description: Sets the signal source (BO/CO parameter, BICO coded) to search in the signal sinks.

The signal source to be searched for is set in p9484 (BICO-coded) and the search result is specified using the

number (r9485) and the first index (r9486).

Dependency: Refer to: r9485, r9486

Description: Displays the number of BICO interconnections to the signal sink being searched for.

r9409 Number of parameters to be saved / Qty par to save

Access level: 4 Calculated: - Data type: Unsigned16

Can be changed: - Scaling: - Dyn. index: -