Siemens SINAMICS G120 - p20104 SUB 0 run-time group; SUB 0 RTG; p20105 SUB 0 run sequence; SUB 0 RunSeq; p20106[0...1] CI: SUB 1 inputs; SUB 1 inputs; r20107 CO: SUB 1 difference Y; SUB 1 difference Y

To Next Page

To Previous Page

SINAMICS G120 Control Units CU240B-2/CU240E-2

List Manual (LH11), 01/2016, A5E33839529

477

2 Parameters

2.2 List of parameters

Description: Setting parameter for the run-time group in which instance SUB 0 of the subtractor is to be called.

Value: 5: Run-time group 5

6: Run-time group 6

9999: Do not calculate

Description: Setting parameter for the run sequence of instance SUB 0 within the run-time group set in p20104.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

Description: Sets the signal source of minuend X1 and subtrahend X2 of instance SUB 1 of the subtractor.

Index: [0] = Minuend X1

[1] = Subtrahend X2

Description: Display parameter for the difference Y = X1 - X2 of instance SUB 1 of the subtractor.

Description: Setting parameter for the run-time group in which instance SUB 1 of the subtractor is to be called.

Value: 5: Run-time group 5

6: Run-time group 6

9999: Do not calculate

p20104 SUB 0 run-time group / SUB 0 RTG

Access level: 3 Calculated: - Data type: Integer16

Can be changed: T Scaling: - Dyn. index: -