Siemens SINAMICS G120 - Fig. 3-43 2503 - Status word sequence control (r0899)

3 Function diagrams 3.7 Internal control/status words
SINAMICS G120 Control Units CU240B-2/CU240E-2
610 List Manual (LH11), 01/2016, A5E33839529
Fig. 3-43 2503 – Status word sequence control (r0899)
- 2503 -
Function diagram
87654321
fp_2503_97_57.vsd
Internal control/status words
G120 CU240B/E-2
09.12.2015 V4.7.6
Status word, sequence control (r0899)
11
12
13
14
15
PROFIdrive-Bit
10
9
8
7
6
5
4
3
0
1
2
r0899.0
r0899.1
r0899.4
r0899.5
r0899.11
r0899.2
r0899.6
r0899.9
r0899.3
r0899.7
r0899.8
1
&
(1)
OFF2 S_src 2
p0845 [C]
(1)
OFF3 S_src 2
p0849 [C]
OFF1
OFF2
OFF3
Enable internal
missing or
fault with
this reaction
From sequence control
[2610]
From sequence control
[2610]
From sequence control
[2610]
From sequence control
[2610]
From sequence control
[2610]
From sequence control
[2610]
From sequence control
[2610]
From sequence control
[2610]
Bit 9 = 1 --> Ready to exchange process
data
From sequence control
[2610]
The drive is ready to accept data.
Status word sequence control (r0899)
1 = Ready for switch on
1 = Ready (DC link loaded, pulses inhibited)
1 = Operation enabled (drive follows n_set)
1 = Jog active
1 = No coast down active (OFF2 inactive)
1 = No quick stop active (OFF3 inactive)
1 = Switching on inhibited active
1 = Drive ready
1 = Controller enable
1 = Control requested
Reserved
1 = Pulses enabled
Reserved
Reserved
ZSW seq_ctrl
r0899
r0899
Bit No.
1 = Command close holding brake
1 = Open holding brakeFrom the brake control [2701.8]
From the brake control [2701.8]
r0899.12
r0899.13
<1>
<1>
[2510.1], [2701.1]
[2510.1], [2701.1]
[2510.1], [4015.1]
[2510.1]
[2510.1]
[2510.1]
[2510.1]
[2510.1]