Siemens SINAMICS G120 - p20114[0...3] CI: MUL 1 inputs; MUL 1 inputs; r20115 CO: MUL 1 product Y; MUL 1 product Y; p20116 MUL 1 run-time group; MUL 1 RTG; p20117 MUL 1 run sequence; MUL 1 RunSeq

To Next Page

To Previous Page

SINAMICS G120 Control Units CU240B-2/CU240E-2

List Manual (LH11), 01/2016, A5E33839529

479

2 Parameters

2.2 List of parameters

Description: Sets the signal source of the factors X0, X1, X2, X3 of instance MUL 1 of the multiplier.

Index: [0] = Factor X0

[1] = Factor X1

[2] = Factor X2

[3] = Factor X3

Description: Display parameter for the product Y = X0 * X1 * X2 * X3 of instance MUL 1 of the multiplier.

Description: Setting parameter for the run-time group in which instance MUL 1 of the multiplier is to be called.

Value: 5: Run-time group 5

6: Run-time group 6

9999: Do not calculate

Description: Setting parameter for the run sequence of instance MUL 1 within the run-time group set in p20116.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

Description: Sets the signal source of dividend X1 and divisor X2 of instance DIV 0 of the divider.

Index: [0] = Dividend X0

[1] = Divisor X1

p20114[0...3] CI: MUL 1 inputs / MUL 1 inputs

Access level: 3 Calculated: - Data type: U32 / FloatingPoint32

Can be changed: T Scaling: PERCENT Dyn. index: -