Siemens SINAMICS G120 - p20151 PCL 0 run-time group; PCL 0 RTG; p20152 PCL 0 run sequence; PCL 0 RunSeq; p20153 BI: PCL 1 input pulse I; PCL 1 inp_pulse I; p20154 PCL 1 pulse duration in ms; PCL 1 pulse_dur ms

2 Parameters
2.2 List of parameters
SINAMICS G120 Control Units CU240B-2/CU240E-2
486 List Manual (LH11), 01/2016, A5E33839529
Description: Setting parameter for the run-time group in which the instance PCL 0 of the pulse shortener is to be called.
Value: 5: Run-time group 5
6: Run-time group 6
9999: Do not calculate
Description: Setting parameter for the run sequence of instance PCL 0 within the run-time group set in p20151.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
Description: Sets the signal source for the input pulse I of instance PCL 1 of the pulse shortener.
Description: Setting parameter for pulse duration T in milliseconds of instance PCL 1 of the pulse shortener.
Description: Display parameter for output pulse Q of instance PCL 1 of the pulse shortener.
Description: Setting parameter for the run-time group in which the instance PCL 1 of the pulse shortener is to be called.
p20151 PCL 0 run-time group / PCL 0 RTG
Access level: 3 Calculated: - Data type: Integer16
Can be changed: T Scaling: - Dyn. index: -
Unit group: - Unit selection: - Func. diagram: 7230
Min Max Factory setting
5 9999 9999
p20152 PCL 0 run sequence / PCL 0 RunSeq
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: T Scaling: - Dyn. index: -
Unit group: - Unit selection: - Func. diagram: 7230
Min Max Factory setting
0 32000 400
p20153 BI: PCL 1 input pulse I / PCL 1 inp_pulse I
Access level: 3 Calculated: - Data type: U32 / Binary
Can be changed: T Scaling: - Dyn. index: -
Unit group: - Unit selection: - Func. diagram: 7230
Min Max Factory setting
- - 0
p20154 PCL 1 pulse duration in ms / PCL 1 pulse_dur ms
Access level: 3 Calculated: - Data type: FloatingPoint32
Can be changed: T Scaling: - Dyn. index: -
Unit group: - Unit selection: - Func. diagram: 7230
Min Max Factory setting
0.00 5400000.00 0.00
r20155 BO: PCL 1 output Q / PCL 1 output Q
Access level: 3 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Dyn. index: -
Unit group: - Unit selection: - Func. diagram: 7230
Min Max Factory setting
- - -
p20156 PCL 1 run-time group / PCL 1 RTG
Access level: 3 Calculated: - Data type: Integer16
Can be changed: T Scaling: - Dyn. index: -
Unit group: - Unit selection: - Func. diagram: 7230
Min Max Factory setting
5 9999 9999