Siemens SINAMICS G120 - p20084 NOT 1 run-time group; NOT 1 RTG; p20085 NOT 1 run sequence; NOT 1 RunSeq; p20086 BI: NOT 2 input I; NOT 2 input I; r20087 BO: NOT 2 inverted output; NOT 2 inv output

To Next Page

To Previous Page

SINAMICS G120 Control Units CU240B-2/CU240E-2

List Manual (LH11), 01/2016, A5E33839529

473

2 Parameters

2.2 List of parameters

Description: Setting parameter for the run-time group in which the instance NOT 1 of the inverter is to be called.

Value: 1: Run-time group 1

2: Run-time group 2

3: Run-time group 3

4: Run-time group 4

5: Run-time group 5

6: Run-time group 6

9999: Do not calculate

Description: Setting parameter for the run sequence of instance NOT 1 within the run-time group set in p20084.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

Description: Sets the signal source of input quantity I of instance NOT 2 of the inverter.

Description: Display parameter for the inverted output of instance NOT 2 of the inverter.

Description: Setting parameter for the run-time group in which the instance NOT 2 of the inverter is to be called.

Value: 1: Run-time group 1

2: Run-time group 2

3: Run-time group 3

4: Run-time group 4

5: Run-time group 5

p20084 NOT 1 run-time group / NOT 1 RTG

Access level: 3 Calculated: - Data type: Integer16

Can be changed: T Scaling: - Dyn. index: -