Siemens SINAMICS G120 - p20327 RSR 2 run-time group; RSR 2 RTG; p20328 RSR 2 run sequence; RSR 2 RunSeq; p20329[0...3] BI: DFR 2 inputs; DFR 2 inputs; r20330 BO: DFR 2 output Q; DFR 2 output Q

To Next Page

To Previous Page

SINAMICS G120 Control Units CU240B-2/CU240E-2

List Manual (LH11), 01/2016, A5E33839529

517

2 Parameters

2.2 List of parameters

Description: Setting parameter for the run-time group in which instance RSR 2 of the RS flipflop is to be called.

Value: 1: Run-time group 1

2: Run-time group 2

3: Run-time group 3

4: Run-time group 4

5: Run-time group 5

6: Run-time group 6

9999: Do not calculate

Description: Setting parameter for the run sequence of instance RSR 2 within the run-time group set in p20327.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

Description: Sets the signal source for trigger input I, D input D, set input S, and reset input R of instance DFR 2 of the D flipflop.

Index: [0] = Trigger input I

[1] = D input D

[2] = Set S

[3] = Reset R

Description: Display parameter for output Q of instance DFR 2 of the D flipflop.

Description: Display parameter for the inverted output QN of instance DFR 2 of the D flipflop.

p20327 RSR 2 run-time group / RSR 2 RTG

Access level: 3 Calculated: - Data type: Integer16

Can be changed: T Scaling: - Dyn. index: -