Siemens SINAMICS G120 - p20094[0...3] CI: ADD 0 inputs; ADD 0 inputs; r20095 CO: ADD 0 output Y; ADD 0 output Y; p20096 ADD 0 run-time group; ADD 0 RTG; p20097 ADD 0 run sequence; ADD 0 RunSeq

To Next Page

To Previous Page

SINAMICS G120 Control Units CU240B-2/CU240E-2

List Manual (LH11), 01/2016, A5E33839529

475

2 Parameters

2.2 List of parameters

Description: Sets the signal source of input quantities X0, X1, X2, X3 of instance ADD 0 of the adder.

Index: [0] = Input X0

[1] = Input X1

[2] = Input X2

[3] = Input X3

Description: Display parameter for the output quantity Y = X0 + X1 + X2 + X3 of instance ADD 0 of the adder.

Description: Setting parameter for the run-time group in which the instance ADD 0 of the adder is to be called.

Value: 5: Run-time group 5

6: Run-time group 6

9999: Do not calculate

Description: Setting parameter for the run sequence of instance ADD 0 within the run-time group set in p20096.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

Description: Sets the signal source of input quantities X0, X1, X2, X3 of instance ADD 1 of the adder.

Index: [0] = Input X0

[1] = Input X1

[2] = Input X2

[3] = Input X3

p20094[0...3] CI: ADD 0 inputs / ADD 0 inputs

Access level: 3 Calculated: - Data type: U32 / FloatingPoint32

Can be changed: T Scaling: PERCENT Dyn. index: -