Siemens SINAMICS G120 - p20376 PLI 0 run-time group; PLI 0 RTG; p20377 PLI 0 run sequence; PLI 0 RunSeq; p20378 CI: PLI 1 input X; PLI 1 input X; r20379 CO: PLI 1 output Y; PLI 1 output Y

To Next Page

To Previous Page

SINAMICS G120 Control Units CU240B-2/CU240E-2

List Manual (LH11), 01/2016, A5E33839529

525

2 Parameters

2.2 List of parameters

[16] = Breakpoint 16

[17] = Breakpoint 17

[18] = Breakpoint 18

[19] = Breakpoint 19

Description: Setting parameter for the run-time group in which instance PLI 0 of the polyline is to be called

Value: 5: Run-time group 5

6: Run-time group 6

9999: Do not calculate

Description: Setting parameter for the run sequence of instance PLI 0 within the run-time group set in p20376.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

Description: Sets the signal source for input X of the polyline (20 breakpoints) of instance PLI 1.

Description: Display parameter for the output quantity Y of the polyline (20 breakpoints) of instance PLI 1

Description: Sets the x-coordinates for the breakpoints (A0...A19) of the polyline (20 breakpoints) of instance PLI 1.

Index: [0] = Breakpoint 0

[1] = Breakpoint 1

[2] = Breakpoint 2

[3] = Breakpoint 3

[4] = Breakpoint 4

[5] = Breakpoint 5

p20376 PLI 0 run-time group / PLI 0 RTG

Access level: 3 Calculated: - Data type: Integer16

Can be changed: T Scaling: - Dyn. index: -