Siemens SINAMICS G120 - 3.7 Internal control;status words

3 Function diagrams
3.7 Internal control/status words
SINAMICS G120 Control Units CU240B-2/CU240E-2
608 List Manual (LH11), 01/2016, A5E33839529
3.7 Internal control/status words
Function diagrams
2501 – Control word sequence control (r0898) 609
2503 – Status word sequence control (r0899) 610
2505 – Control word, setpoint channel (r1198) 611
2510 – Status word 1 (r0052) 612
2511 – Status word 2 (r0053) 613
2512 – Control word 1 (r0054) 614
2513 – Supplementary control word (r0055) 615
2520 – Control word, speed controller (r1406) 616
2522 – Status word, speed controller (r1407) 617
2526 – Status word, closed-loop control (r0056) 618
2530 – Status word, current control (r1408) 619
2534 – Status word monitoring functions 1 (r2197) 620
2536 – Status word monitoring functions 2 (r2198) 621
2537 – Status word monitoring functions 3 (r2199) 622
2546 – Control word, faults/alarms (r2138) 623
2548 – Status word, faults/alarms 1 and 2 (r2139 and r2135) 624
2610 – Sequence control - sequencer 625
2634 – Sequence control - missing enable signals, line contactor control 626