Extended interrupts and events controller (EXTI) RM0440
454/2126 RM0440 Rev 4
Bits 22: 19 SWIx: Software interrupt on line x (x = 22 o 19)
If the interrupt is enabled on this line in the EXTI_IMR, writing a '1' to this bit
when it is at '0' sets the corresponding pending bit in EXTI_PR resulting in an
interrupt request generation.
This bit is cleared by clearing the corresponding bit in the EXTI_PR register (by
writing a ‘1’ into the bit).
Bit 18 Reserved, must be kept at reset value.
Bits 17:0 SWIx: Software interrupt on line x (x = 17 to 0)
If the interrupt is enabled on this line in the EXTI_IMR, writing a '1' to this bit
when it is at '0' sets the corresponding pending bit in EXTI_PR resulting in an
interrupt request generation.
This bit is cleared by clearing the corresponding bit of EXTI_PR (by writing a ‘1’
into the bit).
To Next Page
Loading...
