High-resolution timer (HRTIM) RM0440
980/2126 RM0440 Rev 4
Bit 16 CMP1DE: Compare 1 DMA request enable
This bit is set and cleared by software to enable/disable the compare 1 DMA requests.
0: Compare 1 DMA request disabled
1: Compare 1 DMA request enabled
Bit 15 Reserved, must be kept at reset value.
Bit 14 DLYPRTIE: Delayed protection interrupt enable
This bit is set and cleared by software to enable/disable interrupts on delayed protection.
0: Delayed protection interrupts disabled
1: Delayed protection interrupts enabled
Bit 13 RSTIE: Reset/roll-over interrupt enable
This bit is set and cleared by software to enable/disable interrupts on timer x counter reset or roll-
over in continuous mode.
0: Timer x counter reset/roll-over interrupt disabled
1: Timer x counter reset/roll-over interrupt enabled
Bit 12 RSTx2IE: Output 2 reset interrupt enable
Refer to RSTx1IE description
Bit 11 SETx2IE: Output 2 set interrupt enable
Refer to SETx1IE description
Bit 10 RSTx1IE: Output 1 reset interrupt enable
This bit is set and cleared by software to enable/disable Tx1 output reset interrupts.
0: Tx1 output reset interrupts disabled
1: Tx1 output reset interrupts enabled
Bit 9 SETx1IE: Output 1 set interrupt enable
This bit is set and cleared by software to enable/disable Tx1 output set interrupts.
0: Tx1 output set interrupts disabled
1: Tx1 output set interrupts enabled
Bit 8 CPT2IE: Capture interrupt enable
Refer to CPT1IE description
Bit 7 CPT1IE: Capture interrupt enable
This bit is set and cleared by software to enable/disable capture 1 interrupts.
0: Capture 1 interrupts disabled
1: Capture 1 interrupts enabled
Bit 6 UPDIE: Update interrupt enable
This bit is set and cleared by software to enable/disable update event interrupts.
0: Update interrupts disabled
1: Update interrupts enabled
Bit 5 Reserved, must be kept at reset value.
Bit 4 REPIE: Repetition interrupt enable
This bit is set and cleared by software to enable/disable repetition event interrupts.
0: Repetition interrupts disabled
1: Repetition interrupts enabled
Bit 3 CMP4IE: Compare 4 interrupt enable
Refer to CMP1IE description
To Next Page
Loading...
Need help?
General
