Chapter 4: Management
Extreme Networks EAS 100-24t Switch CLI Manual
54
Example usage
To change the port SNMP notification state:
all - Specifies that TLV protocol data type will be set to all.
eapol - Specifies that TLV protocol data type will be set to EAPOL.
lacp - Specifies that TLV protocol data type will be set to LACP.
gvrp - Specifies that TLV protocol data type will be set to GVRP.
stp - Specifies that TLV protocol data type will be set to STP.
enable - Specifies that the Dot1 TLV Protocol ID option will be enabled.
disable - Specifies that the Dot1 TLV Protocol ID option will be disabled.
dot3_tlvs - Specifies the Dot3 TLVS used.
all - Specifies that all the Dot3 TLVS' will be used.
mac_phy_configuration_status - This TLV optional data type indicates that LLDP agent
should transmit 'MAC/PHY configuration/status TLV'. This type indicates it is possible
for two ends of an IEEE 802.3 link to be configured with different duplex and/or speed
settings and still establish some limited network connectivity. More precisely, the
information includes whether the port support the auto-negotiation function, whether the
function is enabled, the auto-negotiated advertised capability, and the operational MAU
type. The default state is disabled.
link_aggregation - This TLV optional data type indicates that LLDP agent should
transmit 'Link Aggregation TLV'. This type indicates the current link aggregation status
of IEEE 802.3 MACs. More precisely, the information should include whether the port is
capable of doing link aggregation, whether the port is aggregated in a aggregated link,
and the aggregated port ID. The default state is disabled.
power_via_mdi - This TLV optional data type indicates that LLDP agent should transmit
'Power via MDI TLV'. Three IEEE 802.3 PMD implementations (10BASE-T, 100BASE-
TX, and 1000BASE-T) allow power to be supplied over the link for connected non-
powered systems. The Power via MDI TLV allows network management to advertise
and discover the MDI power support capabilities of the sending IEEE 802.3 LAN
station. The default state is disabled.
maximum_frame_size - This TLV optional data type indicates that LLDP agent should
transmit 'Maximum-frame-size TLV. The default state is disabled.
enable - Specifies that the Dot3 TLVS option will be enabled.
disable - Specifies that the Dot3 TLVS option will be disabled.
Restrictions Only Administrator-level users can issue this command.
# config lldp ports 1-5 notification enable
Command: config lldp ports 1-5 notification enable
Success.
#
config lldp ports
To Next Page
Loading...
