Extreme Networks EAS 100-24t Switch CLI

To Next Page

To Previous Page

Network Monitoring Commands

Extreme Networks EAS 100-24t Switch CLI Manual

Parameters <index 1-4> - Specifies that the command will be applied to an index of hosts.

There are four available indexes, numbered 1 through 4.

severity - Severity level indicator. These are described in the following:

Bold font indicates that the corresponding severity level is currently supported

on the switch.

Numerical Severity

Code

• 0 Emergency: system is unusable

• 1 Alert: action must be taken immediately

• 2 Critical: critical conditions

• 3 Error: error conditions

• 4 Warning: warning conditions

• 5 Notice: normal but significant condition

• 6 Informational: informational messages

• 7 Debug: debug-level messages

Numerical Facility

Code

• 0 kernel messages

• 1 user-level messages

• 2 mail system

• 3 system daemons

• 4 security/authorization messages

• 5 messages generated internally by syslog

• 6 line printer subsystem

• 7 network news subsystem

• 8 UUCP subsystem

• 9 clock daemon

• 10 security/authorization messages

create syslog host

Extreme Networks EAS 100-24t Switch CLI - Page 97