HEIDENHAIN MANUALPLUS 620 - Page 600

600 HEIDENHAIN Technical Manual MANUALplus 620
9070 Copy a number from a string 597 110-01 1730
9071 Find the string length 597 110-01 1731
9072 Copy a byte block into a string 597 110-01 1731
9073 Copy a string into a byte block 597 110-01 1732
9084 Display PLC error messages with additional data 597 110-01 1271
9085 Display PLC error message 597 110-01 1272
9086 Clear PLC error message 597 110-01 1273
9087 Status of PLC error message 597 110-01 1274
9095 Activate axis-error compensation 597 110-01 719
9100 Assign data interface 597 110-01 1796
9101 Release data interface 597 110-01 1797
9102 Status of data interface 597 110-01 1798
9103 Transmit string through data interface 597 110-01 1799
9104 Receive string through data interface 597 110-01 1800
9105 Transmit binary data through data interface 597 110-01 1801
9106 Receive binary data through data interface 597 110-01 1802
9107 Binary data from receive buffer 597 110-01 1803
9110 Transmit a message via LSV2 597 110-01
9111 Receive a message via LSV2 597 110-01 1804
9112 Transmit ASCII characters via data interface 597 110-01 1805
9113 Receive ASCII characters via data interface 597 110-01 1806
9117 Reset a BIS C-6002 BALLUFF identification system 597 110-04 –
9118 Read and convert data from a BIS C-6002 BALLUFF
identification system
597 110-04 –
9119 BIS C-6002 BALLUFF processor unit: Write tool data to a
data carrier
597 110-04 –
9120 Position PLC axis 597 110-01 692
9121 Stop PLC axis 597 110-01 693
9122 Status of PLC axis 597 110-01 694
9123 Traverse the reference marks of PLC axes 597 110-01 695
9124 Feed rate override for PLC axis 597 110-01 696
9125 Stop PLC axis at next Hirth grid position 597 110-01 704
9126 Configure axis coupling 597 110-04 773
9127 Request status of an axis coupling 597 110-04 774
9128 Torque limiting by the PLC (in mA or %) 597 110-04 897
9129 Status of torque limiting by the PLC 597 110-04 898
9133 Download the internal ADCs 597 110-01 962
9143 Activate motor brake test 597 110-05 987
9144 Configuration of the emergency stop test 597 110-04 994
9145 Actual-to-nominal value transfer 597 110-01 851
9146 Save and reestablish actual position values 597 110-04 –
9147 Set a reference value 597 110-02 –
9149 Read or set the commutation angle of an axis 597 110-05 –
Module Function SW version Page