Inficon HAPSITE Smart - FCC Information - Information for U.S.A. Users; FCC Statement; FCC RF Exposure Statement

4 - 2
IPN 074-397-P1G
HAPSITE Smart Operating Manual
CAUTION
To maintain compliance with FCC and Industry Canada
(IC) standards and regulations and to ensure the proper
operation of the wireless communication system used
within the Hapsite instrument, ONLY use the antenna that
was originally supplied with the Hapsite instrument. If
you damage the original antenna please contact
INFICON's service department for a replacement antenna
(see Chapter 17 for contact information).
4.2.1 FCC Information — Information for U.S.A. Users
4.2.1.1 FCC Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
 Consult the dealer or an experienced radio / TV technician for assistance.
4.2.2 FCC RF Exposure Statement
WARNING
To satisfy RF exposure requirements, this device and its
antenna must operate with a separation distance of at
least 20 cm from all persons and must not be co-located
or operating in conjunction with any other antenna or
transmitter.