EasyManuals Logo

Inficon HAPSITE Smart User Manual

Inficon HAPSITE Smart
554 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #422 background imageLoading...
Page #422 background image
13 - 10
IPN 074-397-P1G
HAPSITE Smart Operating Manual
The formula used to calculate the amount needed for injection (as above) is as
follows (1 PPB = 1 ng/mL):
X = C
F
/ C
C
x 1000 L/mL x 1 g/1000 ng x 20 mL [1]
where:
X =
L to be Injected
C
F
= Final Desired Concentration in ng/mL (PPB)
C
C
= Calibration Mix Concentration in g/mL (PPM)
6d Uncap a new sample vial, tilt the vial, and transfer the sample from the sample
syringe, taking care to avoid aerating (bubbling) in the sample. Cap the sample
vial tightly. See Figure 13-7.
Figure 13-7 Transferring the Sample to a 40 mL Vial
7 Label the vial with the appropriate information.
13.2.3 Loading the Wells
This section describes the procedure for loading a sample into the well of the HSS.
1 Open the top yellow cover of the HSS to expose the sample needle assembly
and metal heater block with four sample wells.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Inficon HAPSITE Smart and is the answer not in the manual?

Inficon HAPSITE Smart Specifications

General IconGeneral
BrandInficon
ModelHAPSITE Smart
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals