14 - 20
IPN 074-397-P1G
HAPSITE Smart Operating Manual
Figure 14-32 Detach HAPSITE Status
NOTE: The Detach SM procedure normally takes about 3-5 minutes to complete.
Once the Detach SM operation has completed, the system will show the Service
Module Detached screen shown in Figure 14-33.
Figure 14-33 Service Module Detached
To place the Service Module in storage, see section 14.10, Storing the Service
Module, on page 14-22.
14.9 Physically Removing the HAPSITE from the Service Module
The HAPSITE cannot be physically removed from the SM until a "Detach SM" has
been performed, Refer to section 14.8, Detaching the HAPSITE, on page 14-17
before physically removing the HAPSITE from the Service Module.
To Next Page
Loading...
