4 - 1
IPN 074-397-P1G
HAPSITE Smart Operating Manual
Chapter 4
Wireless and USB
4.1 Introduction
The HAPSITE Smart has wireless communication along with a USB drive. The
wireless option is designed for use with Smart IQ software version 1.30 or greater.
Wireless and USB is available as an upgrade for older HAPSITE Smart
instruments.
The HAPSITE contains a wireless transmitter/receiver
that emits electromagnetic radiation (EMR). This
radiation in a tactical or operational environment may
potentially be used to locate the HAPSITE and its
operators. This radiation also has the potential to
detonate some types of unexploded ordnance (UXO), or
improvised explosive devices (IEDs), or both, if the
HAPSITE is transmitting in the safety exclusion area
around the device(s). There is a hardware switch to turn
off the wireless radio so that the HAPSITE may still be
used in areas where these hazards are a concern.
Consult applicable regulations and policies when using
the HAPSITE with the wireless device active in such
environments.
4.2 FCC Compliance Information
This section of the Operating Manual lists FCC and Industry Canada (IC)
compliance information for the HAPSITE Smart system that contains the wireless
communication option.
NOTE: This equipment contains an OEM Embedded Wireless Bridge
(Ethernet to Wireless LAN) Module from DPAC Technologies.
FCC ID: RTTAB-WLNB
IC: 5376A-ABWLNB
This device complies with Part 15 of the FCC Rules and with RSS-210 of
Industry Canada (IC). Operation is subject to the following two conditions:
1 This device may not cause harmful interference, and
2 This device must accept any interference received, including interference
that may cause undesired operation.
To Next Page
Loading...
Need help?
General
