Inficon HAPSITE Smart - 8.2 Computer System Requirements; 8.3 Installing and Updating the HAPSITE Smart and Smart IQ Software

8 - 2
IPN 074-397-P1G
HAPSITE Smart Operating Manual
8.2 Computer System Requirements
The following is the minimum recommended computer system for communication
with one HAPSITE.
Processor . . . . . . . . . . . . . . . . . . . . . Pentium III 550 MHz or greater
RAM . . . . . . . . . . . . . . . . . . . . . . . . . 512 MB or greater
Hard Disk Space
to load Smart IQ . . . . . . . . . . . . . . . . 20 Mb
Hard Disk Space for storage . . . . . . 10 GB
Disk Drives . . . . . . . . . . . . . . . . . . . . (1) Floppy, (1) CD
Monitor . . . . . . . . . . . . . . . . . . . . . . . 15 inch, SVGA or greater
Monitor Resolution . . . . . . . . . . . . . . 1024 x 768 or greater
Communications . . . . . . . . . . . . . . . (1) RS-232 port and (1) Ethernet port
Operating System . . . . . . . . . . . . . . Windows 2000 or XP
8.3 Installing and Updating the HAPSITE Smart
and Smart IQ Software
The steps for installing and updating the Smart IQ software are the same.
CAUTION
The most important point to remember is to always
update the HAPSITE Smart software prior to updating the
Smart IQ software on the computer.
8.3.1 Updating the HAPSITE Smart Software
The HAPSITE Smart is delivered with factory-installed software. These instructions
explain how to upgrade that software.
The HAPSITE will need to be connected to the laptop computer and
communicating. Refer to Section 2.3.6, Connect Laptop (if desired), on page 2-9 if
the HAPSITE and laptop are not connected. Refer to Section 8.6, Establishing
Communications between the HAPSITE and Laptop Computer with a Crossover
Ethernet Cable, on page 8-20 if communications need to be established. With
Smart IQ running:
1 Place the CD containing the HAPSITE Smart software into the CD drive of the
laptop.