8 - 26
IPN 074-397-P1G
HAPSITE Smart Operating Manual
8.6.3 Establishing Communication with the Service Module
Service Module communications will be established automatically if a COM port
has been selected. Smart IQ has been set up with COM1 communications, so
Smart IQ will automatically recognize and communicate when a Service Module is
connected using a RS-232 cable.
In case the COM port communication has been removed, select the Add Port
button, shown in Figure 8-46.
Figure 8-46 Port Settings in System Properties Window
When Add Port is selected, the window shown in Figure 8-47 will appear. Select
the appropriate COM port to add. Select COM1 or the appropriate COM port.
Figure 8-47 Selecting a COM Port to Add
To Next Page
Loading...
Need help?
General
