Inficon HAPSITE Smart - 2.5 HAPSITE Configurations; 2.6 Headspace Sampling System

2 - 12
IPN 074-397-P1G
HAPSITE Smart Operating Manual
2.5 HAPSITE Configurations
There are 6 basic configurations for the HAPSITE. The first three can either be in
portable mode or connected to AC power. Each configuration can be run with or
without the laptop computer connected.
Configuration 1 - HAPSITE with Probe and Sample Loop or concentrator
Configuration 2 - HAPSITE with Headspace Sampling System and Sample Loop
or concentrator tube
Configuration 3 - HAPSITE with SituProbe and Sample Loop or concentrator tube
Configuration 4 - HAPSITE mounted on Service Module with Probe and Sample
Loop or concentrator tube
Configuration 5 - HAPSITE mounted on Service Module with Headspace
Sampling System and Sample Loop or concentrator tube
Configuration 6 - HAPSITE mounted on Service Module with SituProbe and
Sample Loop or concentrator tube
2.6 Headspace Sampling System
The Headspace Sampling System is an accessory used to test water and solid
samples. Samples are heated to release any VOC’s into the sample vial
headspace. The sampling needle is inserted into the vial and the headspace is
sampled through the needle and transfer line, into the HAPSITE.
For additional information on the Headspace Sampling System refer to Chapter 13,
Headspace Sampling System.
2.6.1 Headspace Sampling System - Components Received
Headspace Sampling System (HSS) — The main module, includes the following:
 headspace sampling needle assembly.
 heater block with four sample wells.
 compartment for loading an INFICON Nitrogen Carrier Gas canister.
 compartment for loading an INFICON rechargeable battery, INFICON part
number 930-4061-G1.
 Swagelok® connection for use with an external supply of pressurized Nitrogen.
 power supply connection.
 transfer line connection.