4 - 11
IPN 074-397-P1G
HAPSITE Smart Operating Manual
4.5.3 Configuring the Laptop for Wireless Communication
In order for wireless communication between the laptop and HAPSITE Smart to be
successful, the radio on the laptop computer must be turned on. The basic steps
for configuring the laptop for wireless communication are:
1 Enable the radio on the laptop computer.
2 Scan for available Wireless Networks.
3 Choose HAPSITE Smart.
4 Create a profile for the Wireless Connection.
5 Connect to the HAPSITE Smart wireless network.
6 Verify the connection protocol is 802.11b.
7 If the connection protocol is not 802.11b, modify the profile.
Based on computer model differences between brands and model numbers within
a brand, refer to the User’s Guide of the laptop for specific instructions on setting
up the wireless radio. The Dellâ„¢ website has a section on wireless
communications called the Wireless Center. This section can be accessed at
http://support.dell.com by clicking the Technical Support tab, then selecting
Wireless Center. The content applies to many manufacturer’s laptop computers,
not just Dell laptop computers.
4.6 Wireless Module Indicator Lights
Located on the Wireless Module inside the HAPSITE front cover are four indicator
lights.
RADIO . . . . . . . . . . . . . . . . . . . . . . . When illuminated, the radio is enabled.
WLAN. . . . . . . . . . . . . . . . . . . . . . . . When illuminated, the wireless connection is
linked to the laptop computer. The LED blinks
when transmitting or receiving data.
LAN . . . . . . . . . . . . . . . . . . . . . . . . . When illuminated, the HAPSITE is
connected via a crossover cable to the laptop
computer. The LED blinks when transmitting
or receiving data. The LED will be
extinguished if the crossover cable is
disconnected.
586 . . . . . . . . . . . . . . . . . . . . . . . . . . When illuminated, the HAPSITE 586
processor is linked to a wired or wireless
connection.
To Next Page
Loading...
Need help?
General
