13 - 15
IPN 074-397-P1G
HAPSITE Smart Operating Manual
13.3.3 Cleaning the HSS Wells
The heating block is constructed of aluminum and is normally easy to keep clean.
Routine cleaning of the wells is not usually necessary, but debris and liquids may
be removed easily.
Be careful to avoid burns if the surfaces are hot.
Be careful to avoid injury from the sharp sampling
needle.
The four wells may be cleaned, as necessary, using a damp paper towel or cloth.
Cleaning should be performed after the heating block has been allowed to cool to
ambient temperature or a reasonable temperature to avoid injury.
HINT: When cleaning the wells, position the needle assembly inside a well not
currently being cleaned. Use this as a precaution against possible injury
from the sharp needle point of the assembly.
To remove liquids, roll a paper towel or cloth into a tube shape which will fit easily
into the well, insert, twist and remove.
Loose debris may be removed by turning the HSS upside down with the top door
open. (Remove the battery first to reduce the weight) Make sure no samples are in
the wells before performing this cleaning method.
If necessary, water, solvents, or detergent can be used to clean the wells. Be sure
to think about contamination issues if using anything other than water!
Do not completely fill the vials heater area with any
liquids, since damage to the instrument may result.
To Next Page
Loading...
Need help?
General
