5 - 7
IPN 074-397-P1G
HAPSITE Smart Operating Manual
5.1.1 Quick Reference SOP — Starting the HAPSITE
1 Refer to Section 2.3, Basic Assembly, on page 2-4 for assembly instructions.
2 Turn on the HAPSITE.
3 Plug in the power supply for the laptop computer.
4 Connect the laptop to the HAPSITE with the crossover ethernet cable or enable
the wireless communication connection, see Chapter 4, Wireless and USB.
5 Plug in the mouse (optional).
6 Turn on the laptop.
7 Double-click the Smart IQ software icon.
8 Double-click the Run Method icon.
HINT: If a startup method is enabled the HAPSITE will perform step 8
through step 10.
9 Double-click a Method Folder (e.g., GCMS or Survey).
10 Double-click the desired method. (e.g., Air 15 min Loop, Survey).
11 The HAPSITE will now go through the heat up process and complete an
autotune. This process may take up to 20 minutes. A prompt will appear when
the HAPSITE is ready to begin sampling. Click OK.
To Next Page
Loading...
