11 - 43
IPN 074-397-P1G
HAPSITE Smart Operating Manual
Data File Path . . . . . . . . . . . . . . . . . The entry box for the data file path is used to
specify where this method should save the
data. This entry box is automatically filled
with the default path, derived from the
HAPSITE Properties >> Data Settings
page, if the Use default directory box is
checked.
Save Data . . . . . . . . . . . . . . . . . . . . This selection is always enabled and can not
be changed. Data is saved to the hard drive
in the folder (directory) shown immediately
above this check box.
Save Data to Floppy . . . . . . . . . . . . This parameter, when checked,
automatically saves the data file to the floppy
disk drive of the HAPSITE. Data is also
saved to the hard drive regardless of this
selection. Use of this selection is only
recommended when quick transfer of data
from portable operation is required.
To Next Page
Loading...
Need help?
General
