SENSe Subsystem 10
Keysight N8262A Programming Guide 357
[SENSe[1]]|SENSe2:AVERage2 Commands
These commands control video averaging, which is used to improve measurement
accuracy, for the P-Series power sensor. They combine successive measurements
to produce a new composite result.
The following commands are detailed in this section:
[SENSe[1]]|SENSe2:AVERage2:COUNt <numeric_value>
[SENSe[1]]|SENSe2:AVERage2[:STATe] <boolean>
If the command is used when a sensor other than a P-Series power sensor is
connected, error –241, “Hardware missing” occurs.
To Next Page
Loading...
