Keysight Technologies P Series

SENSe Subsystem 10
Keysight N8262A Programming Guide 401
[SENSe[1]]|SENSe2:TRACe Commands
These commands are used to set:
– The upper and lower limits for the trace display
– The delay between the delayed trigger point and the start of the trace
– The duration of the trace
– The trace units.
The following commands are detailed in this section:
[SENSe[1]]|SENSe2:TRACe:LIMit:LOWer <numeric_value>
[SENSe[1]]|SENSe2:TRACe:LIMit:UPPer <numeric_value>
[SENSe[1]]|SENSe2:TRACe:OFFSet:TIME <numeric_value>
[SENSe[1]]|SENSe2:TRACe:TIME <numeric_value>
[SENSe[1]]|SENSe2:TRACe:UNIT <character_data>
[SENSe[1]]|SENSe2:V2P ATYPe|DTYPe
NOTE
These commands can only be used with P-Series sensors.