Keysight M9421A - Release All (Remote Command Only); Delete Highlighted Analyzer; Delete All

3 WLAN Mode
3.6 Modulation Analysis Measurement
Release All (Remote Command Only)
Release all the selected remote analyzer. The front panel of all the listed remoted
analyzer will be unlocked.
Remote
Command
:SYSTem:COMMunicate:ANALyzer:RELease:ALL
Example
:SYST:COMM:ANAL:REL:ALL
Notes In the “Analyzer Config” view, if the analyzer is released successfully, its “Channel Index” will be set to be
-1
If the local analyzer fails to release a remote analyzer, a warning message, which is “0.0.0.0:0000 cannot
be released.”, will be shown in the message area. However, its “Channel Index” will also be set to be -1
If there is no selected analyzer, no action will be taken and an error message will be generated, for
example, “There is no selected analyzer.”
Delete Highlighted Analyzer
Deletes the highlighted analyzer from the remote analyzer list. You will be prompted
with a dialog box to make sure you REALLY want to do this. The prompt says “The
highlighted analyzer will be permanently deleted from the list. Are you sure you
want to do this? Press Enter to proceed or Cancel (ESC) to cancel.”
Remote
Command
:SYSTem:COMMunicate:ANALyzer:DELete[:IPADdress] <address string>
Example
:SYST:COMM:ANAL:DEL “146.208.172.102:5025”
Notes The parameter of this SCPI command is the IP address and SCPI socket port number of the analyzer in
the remote analyzer list which the user wants to delete
If the parameter is not a valid IP address and SCPI socket port number, for example, the IP address with
a wrong format or not in the list of the remote analyzers, only the valid IP address will be accepted and
an error message will be generated, for example, “Invalid IP address and SCPI socket port:
0.0.0.0:0000.”
If the user tries to delete a selected analyzer, the local analyzer will first try to release the selected
analyzer and then remove it from the list of the remote analyzers. If there is some errors during
releasing the selected analyzer, an error message will be generated, for example, “Cannot release
0.0.0.0:0000.”. However, this analyzer will still be removed from the remote analyzer list
Delete All
Deletes all analyzers in the remote analyzer list. You will be prompted with a dialog
box to make sure you REALLY want to do this. The prompt says “All analyzers will be
permanently deleted. Are you sure you want to do this? Press Enter to proceed or
Cancel (ESC) to cancel.”
1081 WLAN Mode User's &Programmer's Reference