3 WLAN Mode
3.6 Modulation Analysis Measurement
Remote
Command
:SYSTem:COMMunicate:ANALyzer:DELete:ALL
Example
:SYST:COMM:ANAL:DEL:ALL
Notes If there is a selected analyzer, the local analyzer will first try to release the selected analyzer and then
remove it from the list of the remote analyzers. If there is some errors during releasing the selected
analyzer, an error message will be generated, for example, “Cannot release 0.0.0.0.0000”. However,
this analyzer will still be removed from the remote analyzer list
Query Analyzer Information (Remote Command Only)
Gets the information of the remote analyzer.
The query result will be returned in a string in the following format:
Channel Index, Selection State, Verification State, IP Address, *IDN?
For example, “2, Selected, Verified,146.208.172.102:5025,Keysight
Technologies,N9020A,MY46471851,A.12.00_P0012”
Remote
Command
:SYSTem:COMMunicate:ANALyzer:INFormation? <address string>
Example
:SYST:COMM:ANAL:INF? “146.208.172.102:5025”
Notes The parameter of the SCPI command is the IP address and SCPI socket port number of the analyzer of
the remote analyzer list
If the parameter in an invalid IP address, for example an IP address with a wrong format or not in the list
of the remote analyzers, an error message will be generated, for example, “Invalid IP address and SCPI
socket port 0.0.0.0:0000.”
If the current analyzer is not selected, the Channel Index will be “-1”
Query All Analyzer IP Addresses (Remote Query Only)
Gets the IP addresses of all analyzers in the list of the remote analyzers.
The query result will be returned in a string containing all IP addresses and SCPI
socket port number of the analyzer in the remote analyzer list which is separated by
comma:
146.208.172.102:5125,146.208.172.102:5225,146.208.172.102:5325
Remote Command
:SYSTem:COMMunicate:ANALyzer[:IPADdress]?
Example
:SYST:COMM:ANAL?
Query remote analyzer MIMO capability (Remote Query Only)
Query the MIMO capability of the remote analyzers.
WLAN Mode User's &Programmer's Reference 1082
To Next Page