Keysight M9421A - Scale;Div

3 WLAN Mode
3.8 Power vs Time Measurement
Fall: 3
Example
:DISP:PVT:WIND:TRAC:Y:SCAL:RLEV 5
:DISP:PVT:WIND:TRAC:Y:SCAL:RLEV?
Couplings When Auto Scaling is On (default), this value is automatically determined by the measurement result.
When you set a value manually, Auto Scaling changes to Off. Attenuation is not coupled to Ref Value.
Preset 10.00 dBm ! 1-Burst
0.00 dBm ! 2-Rise
0.00 dBm ! 3-Fall
State Saved Saved in instrument state
Backwards Compatibility SCPI
Window Numbers used to be a combination of View and Window, now the VIEW
node is not used and defaults to 1. All Windows are referenced through VIEW1. For
backwards compatibility the old View and Window numbers are honored as below:
Window Old SCPI Command New SCPI Command
PVT -
Burst
:DISP:PVT:VIEW
[1]:WIND:TRAC:Y:SCAL:RLEV 5dBm
:DISP:PVT:WIND1:TRAC:Y:SCAL:RLEV
5dBm
PVT – Rise :DISP:PVT:VIEW2:WIND:TRAC:Y:SCAL:RLEV
5dBm
:DISP:PVT:WIND2:TRAC:Y:SCAL:RLEV
5dBm
PVT – Fall :DISP:PVT:VIEW2:WIND2:TRAC:Y:SCAL:RLE
V 5dBm
:DISP:PVT:WIND3:TRAC:Y:SCAL:RLEV
5dBm
Scale/Div
Scale/Div sets the height of one division of the graticule in the current Y-Axis unit.
Scale/Div also determines the displayed amplitude range in the log plot graph.
Since there are usually 10 vertical graticule division on the display, the total
amplitude range of the graph is typically 10x this amount. For example, if Scale/Div
is 10 dB, then the total range of the graph is 100 dB.
Remote Command
:DISPlay:PVTime:WINDow[1]|2|3:TRACe:Y[:SCALe]:PDIVision <rel_ampl>
:DISPlay:PVTime:WINDow[1]|2|3:TRACe:Y[:SCALe]:PDIVision?
Window numbers are as follows:
Burst: 1
Rise: 2
Fall: 3
Example
:DISP:PVT:WIND:TRAC:Y:PDIV 5
1-Burst for Transmit On/Off Power
WLAN Mode User's &Programmer's Reference 1314