3 WLAN Mode
3.7 WLAN MIMO Modulation Analysis Measurement
3.7.9 Meas Setup
The Meas Setup menu panel contains functions for setting up the measurement
parameters and also contains functions for setting up parameters global to all
measurements in the mode.
3.7.9.1 Settings
The Settings tab contains frequently used Meas Setup functions to which you will
want the fastest access.
Avg|Burst Number
Used to specify the number of data acquisitions that are averaged. After the
specified number of average counts, the averaging mode (termination control)
setting determines the averaging action.
Avg number is the number of bursts, is NOT the number of data acquisition. If search
length is large enough to include all the bursts, acquisition will only execute once
(single mode). If the bursts number include in one capture is smaller than average
number, multi capture and measurement is necessary.
–
On – Sets measurement averaging on
–
Off – Sets measurement averaging off
Remote
Command
[:SENSe]:EVMMimo:AVERage:COUNt <integer>
[:SENSe]:EVMMimo:AVERage:COUNt?
Example
:EVMM:AVER:COUN 1
:EVMM:AVER:COUN?
Preset 10
State Saved Saved in instrument state
Min 1
Max 10000
Averaging On/Off
Turns averaging on or off.
Remote Command
[:SENSe]:EVMMimo:AVERage[:STATe] OFF | ON | 0 | 1
[:SENSe]:EVMMimo:AVERage[:STATe]?
WLAN Mode User's &Programmer's Reference 1196
To Next Page