3 WLAN Mode
3.7 WLAN MIMO Modulation Analysis Measurement
:CALC:EVMM:EQU:TMOD?
Preset SEQ
State Saved Saved in instrument state
Range Channel Estimation Sequence Only | Channel Estimation Sequence&Data
I/Q Normalize
This parameter specifies if the I/Q signals will be normalized.
Remote Command
:CALCulate:EVMMimo:IQNorm OFF | ON | 0 | 1
:CALCulate:EVMMimo:IQNorm?
Example
:CALC:EVMM:IQN ON
:CALC:EVMM:IQN?
Preset ON
State Saved Saved in instrument state
Range On | Off
Multi-Carrier Filter
Specifies whether or not to apply a filter to filter out adjacent carriers.
When there are adjacent carriers to the BW of interest, this multi-carrier filter can
be used to filter out the unwanted carriers and minimize leakage into the BW of
interest.
Remote Command
:CALCulate:EVMMimo:MCFilter[:STATe] ON | OFF | 1 | 0
:CALCulate:EVMMimo:MCFilter[:STATe]?
Example
:CALC:EVMM:MCF 1
:CALC:EVMM:MCF?
Notes It’s NOT available when Radio Standard is 802.11ac/ax 80+80MHz
Preset OFF
State Saved Saved in instrument state
Range ON | OFF
Spectrum
Sets a spectrum to either normal or to inverted for demodulation related
measurements. If set to INVert, the upper and lower spectrums are swapped.
The invert function conjugates the spectrum, which is equivalent to taking the
negative of the quadrature component in demodulation. The correct setting (Normal
WLAN Mode User's &Programmer's Reference 1244
To Next Page
Loading...
