7 Save/Recall/Print
7.3 Save
7.3.56 Data Type (WLAN EVM / MIMO EVM Measurement)
You can save an OFDMA setup file for future recall.
See RU Allocation Setup File (*.csv) Format for more details.
Remote Command
:MMEMory:STORe:RUALlocation <fileName>
Example
:MMEM:STOR:RUAL "mySetup.csv"
Status Bits/OPC depend-
encies
Sequential - aborts the current measurement
Backwards Compatibility
SCPI
:MMEMory:STORe:AXConfig <fileName>
7.3.57 Reference Symbols
Saves the Reference Symbols (I/Q data) to a file.
Remote
Command
:MMEMory:STORe:REFS <filename>
Example
:MMEM:STOR:REFS ‘RefSymbols_0001.csv'
Notes The file format interleaves I/Q ref symbols without commas, for example:
I
Q
I
Q
…
Status Bits/OPC
dependencies
Sequential - aborts the current measurement
7.3.58 Screen Image
Selects a file for saving the contents of the display.
Screen Image files are PNG (Portable Network Graphics) files with the same
resolution as the data display. They contain the image that was on the screen before
you opened the Save dialog. When the Screen Image key is pressed, a "thumbnail"
of the captured image is displayed, with the note “This is the image that will be
saved” below it.
After you have completed the save, a message “File image.png saved” (assuming
image.png was the filename you used).
WLAN Mode User's &Programmer's Reference 2427
To Next Page