3 WLAN Mode
3.4 SEM Measurement
3.4.10 Results for n = 16
If the result is not available, NaN (9.91E+37) is returned
Returns two carriers’ comma-separated scalar results when the radio standard is
802.11ac 80+80 MHz. Returns NaN otherwise
1.
Absolute power of carrier segment 1 (dBm)
2.
Absolute power of carrier segment 2 (dBm)
3.4.11 Results for n = 18-20
n Return Value
18 Returns the displayed frequency domain spectrum trace data for Trace 2 separated by commas
19 Returns the displayed frequency domain spectrum trace data for Trace 3 separated by commas
20 Returns the displayed frequency domain absolute 2 limit trace data, separated by commas
3.4.12 Number of Offsets
The number of available offsets varies depending on the mode and option as below.
Mode Number of
available offsets
MSR LTEAFDD, LTEATDD, 5G NR 12 (Offset A to L)
WLAN 14 (Offset A to N)
Other Modes with option: N9060A-7FP, N9060B-2FP, N9060C-2FP,
N9060EM1D, N9060EM1E, or N90EMPSMB
12 (Offset A to L)
Other Modes without option N9060A-7FP, N9060B-2FP, N9060C-2FP,
N9060EM1D, N9060EM1E, or N90EMPSMB
6 (Offset A to F)
3.4.13 Views
All Modes provide three predefined views. In MSR, LTE-Advanced FDD/TDD and 5G
NR Modes, there is also a fourth predefined view. The views are listed in the table
below.
In the following table:
–
The Enumerated ID is used with :DISP:SEM:VIEW
–
The Numeric ID is used with :DISP:SEM:VIEW:NSEL
WLAN Mode User's &Programmer's Reference 474
To Next Page
Loading...
