Keysight M9421A - 3.8.1 Windows

3 WLAN Mode
3.8 Power vs Time Measurement
:CONFigure:PVTime
:CONFigure:PVTime:NDEFault
:INITiate:PVTime
:FETCh:PVTime[n]?
:READ:PVTime[n]?
:MEASure:PVTime[n]?
Remote Command SCPI Results for Power vs Time Measurement
Index N Results Returned
0 Returns unprocessed I/Q trace data, as a series of comma-separated trace points, in
volts. The I values are listed first in each pair, using the 0 through even-indexed
values. The Q values are the odd-indexed values.
not specified
or n = 1
Returns 12 comma-separated scalar results, in the following order:
1.
Return -999.0 ( BWCC to PSA WLAN)
2.
Return Power-on Ramp Time (us)
3.
Return Power-down Ramp Time (us)
4.
Return overall PASS/FAIL (0:Pass, 1: Fail)
5.
Return Power-on Ramp PASS/FAIL (0:Pass, 1: Fail)
6.
Return Power-down Ramp PASS/FAIL (0:Pass, 1: Fail)
7.
Return Start Level (dBm) for ramp up
8.
Return Start Level (dBm) for ramp down
9.
Return Stop Level (dBm) for ramp up
10.
Return Stop Level (dBm) for ramp down
11.
Return Max Ramp Up Time (us) (limit value)
12.
Return Max Ramp Down Time (us) (limit value)
2 Return waveform of Power-on Ramp, the length is determined by Ramp Time Length
3 Return waveform of Power-down Ramp, the length is determined by Ramp Time
Length
4 Return waveform of full burst, the length is actual burst length
Selects the Power vs Time measurement.
3.8.1 Windows
The following windows are available in the Power vs Time measurement.
1311 WLAN Mode User's &Programmer's Reference