3 WLAN Mode
3.8 Power vs Time Measurement
The displayed average/hold, K, shows the count for the sweep (data acquisition) in
progress. K = k + 1, with a limit of N. The displayed value K changes from its previous
value to 1 as soon as the trigger condition for the first data acquisition (sweep) is
met.
Pause/Resume
Pauses a measurement after the current data acquisition is complete.
When paused, the label on the control changes to Resume. Pressing Resume un-
pauses the measurement. When paused, pressing Restart performs a Resume.
Remote Command
:INITiate:PAUSe
:INITiate:RESume
Example
:INIT:PAUS
:INIT:RES
Dependencies Not displayed in Modes that do not support pausing
Annotation Only on control
3.8.8.2 X Scale
This tab accesses controls that enable you to configure the Sweep and Control
functions of the analyzer, such as Sweep Rules.
Ref Value
Enables you to set the display X reference value.
Remote
Command
:DISPlay:PVTime:WINDow[1]|2|3:TRACe:X[:SCALe]:RLEVel <time>
:DISPlay:PVTime:WINDow[1]|2|3:TRACe:X[:SCALe]:RLEVel?
Window numbers are as follows:
Burst: 1
Rise: 2
Fall: 3
Example
:DISP:PVT:WIND:TRACE:X:RLEV 1s
1-Burst for Transmit On/Off Power
:DISP:PVT:WIND:TRACE:X:RLEV?
1-Burst for Transmit On/Off Power
:DISP:PVT:WIND2:TRAC:X:RLEV 1s
2-Rise for Transmit On/Off Power
:DISP:PVT:WIND3:TRAC:X:RLEV 1s
1403 WLAN Mode User's &Programmer's Reference
To Next Page