3 WLAN Mode
3.7 WLAN MIMO Modulation Analysis Measurement
–
Zero span measurement Resolution Bandwidth
–
Zero span measurement Dwell Time
Harmonics (SA Mode only)
Parameters affected by Auto Couple are:
–
Resolution Bandwidth
–
Fundamental Frequency
–
Dwell Time
–
Range Table Resolution Bandwidths
–
Range Table Dwell Times
Meas Preset
Restores all the measurement parameters to their default values.
Remote Command
:CONFigure:EVMMimo
Example
:CONF:EVMM
3.7.9.2 Radio
Contains controls to select Radio Standard and settings.
Radio Std Detection
Enables automatic detection of the radio standard of a WLAN signal from DUT. The
auto detection can detect all WLAN family, except 802.11ah.
This function is available for Modulation Analysis and Spectral Flatness
measurements. In other measurements, when Auto is selected, error message “-221
Setting conflict, Auto detection is not available for current measurement” appears.
When Radio Std Detection is Auto, Radio Std is grayed-out.
When set to Man, the radio standard is determined by "Radio Std" on page 1835.
The default settings is Manual.
Remote
Command
[:SENSe]:RADio:STANdard[:WLAN]:DETect:AUTO OFF | ON | 0 | 1
[:SENSe]:RADio:STANdard[:WLAN]:DETect:AUTO?
WLAN Mode User's &Programmer's Reference 1206
To Next Page
Loading...
