3 WLAN Mode
3.4 SEM Measurement
Compatibility
SCPI
Auto Scaling
Toggles the scale coupling function On or Off.
Remote
Command
:DISPlay:SEMask:WINDow[1]:TRACe:X[:SCALe]:COUPle 0 | 1 | OFF | ON
:DISPlay:SEMask:WINDow[1]:TRACe:X[:SCALe]:COUPle?
Example
:DISP:SEM:WIND:TRAC:X:COUP ON
:DISP:SEM:WIND:TRAC:X:COUP?
Couplings When Auto Scaling is ON and the Restart front-panel key is pressed, this function automatically
determines the scale per division and reference values based on the measurement results
When you set a value to either "Scale/Div" on page 650 or "Ref Value" on page 649 manually, Auto
Scaling automatically changes to OFF
Preset
ON
State Saved Saved in instrument state
Range
OFF|ON
Backwards
Compatibility
SCPI
:DISPlay:SEMask:VIEW[1]:WINDow[1]:TRACe:X[:SCALe]:COUPle
3.4.21.3 Sweep Config
Accesses controls that enable you to configure the Sweep and Control functions of
the instrument, such as Sweep Rules.
Points
Sets the number of points displayed in the traces. The current value of points is
displayed in the bottom-right corner of the display.
Remote Command
[:SENSe]:SEMask:SWEep:POINts <integer>
[:SENSe]:SEMask:SWEep:POINts?
Example
:SEM:SWE:POIN 4001
:SEM:SWE:POIN?
Preset 2001
State Saved Saved in instrument state
Min 201
651 WLAN Mode User's &Programmer's Reference
To Next Page