Keysight M9421A - 3.8.2.2 Attenuation

3 WLAN Mode
3.8 Power vs Time Measurement
Burst: 1
Rise: 2
Fall: 3
Example
:DISP:PVT:WIND:TRAC:Y:COUP ON
1-Burst for Transmit On/Off Power
:DISP:PVT:WIND:TRAC:Y:COUP? !
1-Burst for Transmit On/Off Power
:DISP:PVT:WIND2:TRAC:Y:COUP ON
2-Rise for Transmit On/Off Power
:DISP:PVT:WIND3:TRAC:Y:COUP?
2-Fall for Transmit On/Off Power
Couplings When Auto Scaling is On, and the Restart front-panel key is pressed, this function automatically sets
the scale per division to 10 dB and determines the reference values based on the measurement results.
When you set a value to either Scale/Div or Ref Value manually, Auto Scaling automatically changes to
Off.
Preset 1
State Saved Saved in instrument state.
Range On|Off
Backwards Compatibility SCPI
Window Numbers used to be a combination of View and Window, now the VIEW
parameter is not used and defaults to 1. All Windows are referenced through
VIEW1. For backwards compatibility the old View and Window numbers are
honored as below:
Window Old SCPI Command New SCPI Command
PVT - Burst :DISP:PVT:VIEW[1]:WIND:TRAC:Y:COUP ON :DISP:PVT:WIND[1]:TRAC:Y:COUP
ON
PVT – Rise :DISP:PVT:VIEW2:WIND:TRAC:Y:COUP ON DISP:PVT:WIND2:TRAC:Y:COUP ON
PVT – Fall :DISP:PVT:VIEW2:WIND2:TRAC:Y:COUP ON DISP:PVT:WIND3:TRAC:Y:COUP ON
3.8.2.2 Attenuation
Controls the attenuator functions and interactions between the attenuation system
components.
There are two attenuator configurations in the X-Series. One is a Dual-Attenuator
configuration consisting of a mechanical attenuator and an optional electronic
attenuator. The other configuration uses a single attenuator with combined
1317 WLAN Mode User's &Programmer's Reference