3 WLAN Mode
3.7 WLAN MIMO Modulation Analysis Measurement
If the items are OK, the new remote analyzer will be inserted at the end of the
remote analyzer list.
The “Add” softkey will not work if the count of the list of the remote analyzers has
reached 10.
Remote
Command
:SYSTem:COMMunicate:ANALyzer:ADD[:IP
ADdress]
<address
string>
Example
:SYST:COMM:ANAL:ADD “146.208.172.102:5025”
Notes If no supported analyzer is found at the specified address, an error message will be generated, for
example, “Invalid IP address and SCPI socket port 0.0.0.0:0000”
The maximum number of analyzers is 10.If the user tries to add a new analyzer after the maximum
number is reached, an error message will be generated, for example, “Maximum number of analyzer is
reached.”
Verify Highlighted Analyzer
This key verifies the LAN interface connection to the Current Analyzer (It does NOT
verify any signal connections.)
Each time after a new remote analyzer is inserted into the remote analyzer list, its
state is “Unverified”.
When you press this key, the connection to the current analyzer will be verified. If
the analyzer can be verified successfully, its “Verified” state will become “Yes”,
otherwise its state will be “No”.
Verification includes the following items for all platforms:
1.
Whether the remote analyzer with the IP address can be visited by TCPIP.
2.
Whether XA is started in the remote analyzer.
3.
Whether the firmware of the remote analyzer is A.13.00 or a newer one.
4.
Whether the remote analyzer has B40 option or not.
And for modular platforms also include:
5.
Whether the HW of the remote analyzer can support MIMO or not.
6.
Whether the remote Application in the remote analyzer is available.
Remote
Command
:SYSTem:COMMunicate:ANALyzer:VERify
<address
string>
Example
:SYST:COMM:ANAL:VER “146.208.172.102:5025”
Notes The parameter of the SCPI command is the IP address and SCPI socket port number of the analyzer in
the remote analyzer list
1287 WLAN Mode User's &Programmer's Reference
To Next Page