3 WLAN Mode
3.10 Power Stat CCDF Measurement
Example
:PST:IF:GAIN:AUTO ON
:PST:IF:GAIN:AUTO?
Couplings Auto sets IF Gain to High Gain if the input attenuator is set to 0 dB, or the preamp is turned on, or the
Max Mixer Level is −20 dBm or lower
For other conditions, Auto sets IF Gain to Low Gain
Preset
OFF
IF Upsampling Ratio
Allows you to select the upsampling ratio after data is captured for a measurement.
Using this method, mitigation of peak detection error can be expected when
upsampling ratio is set to > x1.
Remote Command
[:SENSe]:PSTatistic:URATio X1 | X2 | X4 | X8 | X16 | X32
[:SENSe]:PSTatistic:URATio?
Example
:PST:URAT X8
:PST:URAT?
Notes X1 is for backwards compatibility
Preset
X1
State Saved Yes, Saved in instrument state
Range
X1|X2|X4|X8|X16|X32
3.10.8.4 Global
The controls in this menu apply to all Modes in the instrument.
Some controls (for example, "Global Center Freq" on page 1850) allow you to switch
certain Meas Global parameters to a Mode Global state. These switches apply to all
Modes that support global settings. For example, no matter what Mode you are in
when you set Global Center Freq to ON, it applies to all Modes that support Global
settings.
Other controls (for example, Extend Low Band) are actually set in this menu, but
apply to all Modes.
Global Center Freq
The software maintains a Mode Global value called Global Center Freq.
When Global Center Freq is switched ON, the current Mode’s center frequency is
copied into the Global Center Frequency, and from then on all Modes that support
WLAN Mode User's &Programmer's Reference 1618
To Next Page