Keysight M9421A - Burst Time; Ramp Time Length

3 WLAN Mode
3.8 Power vs Time Measurement
Remote
Command
[:SENSe]:PVTime:AVERage:TCONtrol EXPonential | REPeat
[:SENSe]:PVTime:AVERage:TCONtrol?
Example
:PVT:AVER:TCON REP
:PVT:AVER:TCON?
Preset EXPonential
State Saved Yes
Range Exponential|Repeat
Burst Time
This parameter specifies the accurate burst length for RF burst to be measured. It is
needed to be set as accurate as possible, or the ramp down time may be lost.
Remote Command
[:SENSe]:PVTime:BURSt:WIDTh <time>
[:SENSe]:PVTime:BURSt:WIDTh?
Example
:PVT:BURS:WIDT 1.0 ms
:PVT:BURS:WIDT
Preset 965.455 us ( 1024bytes, 11M CCK modulation, long preamble)
State Saved Yes
Min 1.0 us
Max 20.0 ms
Backwards Compatibility
SCPI
[:SENSe]:PVTime:BURSt:TIME <time>
[:SENSe]:PVTime:BURSt:TIME?
Ramp Time Length
This parameter indicates the searching window length from which the ramp on and
down is searched. If it is set shorter than actual ramp time, the ramp may be lost.
Remote Command
[:SENSe]:PVTime:RSLength <time>
[:SENSe]:PVTime:RSLength?
Example
:PVT:RSL 1.0 ms
:PVT:RSL?
Preset 15.0 us
State Saved Yes
Min 1.0 us
Max 50.0 us
WLAN Mode User's &Programmer's Reference 1388