Keysight M9421A - Offset;Limits Config Table; 3.4.20.4 Radio; Radio Std

3 WLAN Mode
3.4 SEM Measurement
Offset/Limits Config Table
This function is the same as "Offset/Limits Config Table" on page 555 under the
"Settings" on page 550 tab.
Sets the power reference in the carrier that will be used to compute the relative
values for the offsets.
3.4.20.4 Radio
Contains controls to select Radio Standard and settings.
Radio Std
In this menu, 7 groups of WLAN standards can be selected:
1.
802.11a/b/g/j/p includes 802.11a/g/j/p,802.11b/g,802.11g DSSS-OFDM,
802.11j/p 10M, 802.11p 5M
2.
802.11n includes 802.11n 20MHz and 802.11n 40MHz
3.
802.11ac includes 802.11ac 20MHz, 802.11ac 40MHz, 802.11ac 80MHz,
802.11ac 80+80MHz and 802.11ac 160MHz
4.
802.11ah includes 802.11ah1MHz, 802.11ah2MHz, 802.11ah4MHz,
802.11ah 8MHz, and 802.11ah16MHz
5.
802.11af includes 802.11af 6MHz, 802.11af 7MHz and 802.11af 8MHz
6.
802.11ax includes 802.11ax 20MHz, 802.11ax 40MHz, 802.11ax 80MHz,
802.11ax 80+80MHz and 802.11ax 160MHz
7.
802.11be includes 802.11be 20MHz, 802.11be 40MHz, 802.11be 80MHz,
802.11be 160MHz and 802.11be 320MHz
Below each standard, parameters related to demodulation can be set, such as
Modulation Format, Guard Interval, and so on.
Remote
Command
[:SENSe]:RADio:STANdard[:WLAN] AG | BG | GDO | N20 | N40 AC20 | AC40 | AC80 |
ACT80 | AC160 | AH1 | AH2 | AH4 | AH8 | AH16 | JP10 | P5 | AF6 | AF7 | AF8 |
AX20 | AX40 | AX80 | AXT80 | AX160 | BE20 | BE40 | BE80 | BE160 | BE320
[:SENSe]:RADio:STANdard[:WLAN]?
Example
:RAD:STAN AG
:RAD:STAN?
Notes If the command is sent with unsupported parameters, an error is generated “Settings conflict; option
not installed”
635 WLAN Mode User's &Programmer's Reference