Keysight M9421A - Next Pk Right; Next Pk Left; Minimum Peak

3 WLAN Mode
3.6 Modulation Analysis Measurement
Next Pk Right
Moves the selected marker to the nearest peak right of the current marker that
meets all enabled peak criteria. If there is no valid peak to the right of the current
marker position, a “No peak found” message is generated, and the marker is not
moved.
If the selected marker was off, then it is turned on as a normal marker and a peak
search is performed.
Remote Command
:CALCulate:EVM:MARKer[1]|2|…|12:MAXimum:RIGHt
Example
:CALC:EVM:MARK2:MAX:RIGH
Notes Sending this command selects the subopcoded marker
State Saved Not saved in instrument state
Next Pk Left
Moves the selected marker to the nearest peak left of the current marker that meets
all enabled peak criteria (see Peak Search Config, Section 4.4). If there is no valid
peak to the left of the current marker position, a “No peak found” message is
generated, and the marker is not moved.
If the selected marker was off, then it is turned on as a normal marker and a peak
search is performed.
Remote Command
:CALCulate:EVM:MARKer[1]|2|…|12:MAXimum:LEFT
Example
:CALC:EVM:MARK2:MAX:LEFT
State Saved Not saved in instrument state
Minimum Peak
Moves the selected marker to the minimum y-axis value on the current trace.
Minimum (negative) peak searches do not have to meet the peak search criteria. It
just looks for the lowest y-axis value. If the selected marker is Off, it is turned on
before the minimum search is performed.
Remote Command
:CALCulate:EVM:MARKer[1]|2|…|12:MINimum
Example
:CALC:EVM:MARK2:MIN
Notes Sending this command selects the subopcoded marker
State Saved Not saved in instrument state
965 WLAN Mode User's &Programmer's Reference