Keysight M9421A - Ref Position

3 WLAN Mode
3.8 Power vs Time Measurement
:DISP:PVT:WIND:TRAC:Y:PDIV?
1-Burst for Transmit On/Off Power
:DISP:PVT:WIND2:TRAC:Y:PDIV 10
2-Rise for Transmit On/Off Power
:DISP:PVT:WIND3:TRAC:Y:PDIV 10
3-Fall for Transmit On/Off Power
Dependencies In measurements that support both Log and Lin scales, Scale/Div is grayed out in linear Y scale.
Sending the equivalent SCPI command does change the Scale/Div, though it has no affect while in
Lin.
Couplings In measurements that support Auto Scaling, when the Auto Scaling is On, this value is automatically
determined by the measurement result. When you set a value manually, Auto Scaling automatically
changes to Off.
Preset 10.00 dB / Div
State Saved Saved in instrument state
Min 0.10 dB
Max 20dB
Annotation <value> dB/ left upper of graph ! all measurements unless noted
In log scale, the Scale/Div is shown in the upper left side of the display. In Lin mode, no annotation is
displayed. ! Swept SA
Backwards Compatibility SCPI
Window Numbers used to be a combination of View and Window, now the VIEW
parameter is not used and defaults to 1. All Windows are referenced through
VIEW1. For backwards compatibility the old View and Window numbers are
honored as below:
Window Old SCPI Command New SCPI Command
Burst :DISP:PVT:VIEW[1]:WIND:TRAC:Y:PDIV 10 :DISP:PVT:WIND1:TRAC:Y:PDIV 10
Rise :DISP:PVT:VIEW2:WIND:TRAC:Y:PDIV 10 :DISP:PVT:WIND2:TRAC:Y:PDIV 10
Fall :DISP:PVT:VIEW2:WIND2:TRAC:Y:PDIV 10 :DISP:PVT:WIND3:TRAC:Y:PDIV 10
Ref Position
Positions the reference level at the top, center, or bottom of the Y Scale display.
Changing the reference position does not change the reference level value.
Remote
Command
:DISPlay:PVTime:WINDow[1]|2|3:TRACe:Y[:SCALe]:RPOSition TOP | CENTer | BOTTom
:DISPlay:PVTime:WINDow[1]|2|3:TRACe:Y[:SCALe]:RPOSition?
Window numbers are as follows:
1315 WLAN Mode User's &Programmer's Reference