3 WLAN Mode
3.9 Spectral Flatness Measurement
3.9.8.1 Settings
The Settings tab contains frequently used Meas Setup functions to which you will
want the fastest access.
Avg|Hold Number
Used to specify the number of data acquisitions that are averaged. After the
specified number of average counts, the averaging mode (termination control)
setting determines the averaging action.
–
On - Sets measurement averaging on.
–
Off - Sets measurement averaging off.
Remote
Command
[:SENSe]:FLATness:AVERage:COUNt <integer>
[:SENSe]:FLATness:AVERage:COUNt?
Example
:FLAT:AVER:COUN 1
:FLAT:AVER:COUN?
Preset 10
State Saved Saved in instrument state.
Min/Max 1/10000
Turns averaging on or off.
Remote Command
[:SENSe]:FLATness:AVERage[:STATe] OFF | ON | 0 | 1
[:SENSe]:FLATness:AVERage[:STATe]?
Example
:FLAT:AVER OFF
:FLAT:AVER?
Preset ON
State Saved Yes
Range On|Off
Averaging Mode
Selects the type of termination control used for the averaging function. This
determines the averaging action after the specified number of data acquisitions
(average count) is reached.
1489 WLAN Mode User's &Programmer's Reference
To Next Page
Loading...
