3 WLAN Mode
3.6 Modulation Analysis Measurement
–
Resolution Bandwidth
–
Fundamental Frequency
–
Dwell Time
–
Range Table Resolution Bandwidths
–
Range Table Dwell Times
Meas Preset
Restores all the measurement parameters to their default values.
Remote Command
:CONFigure:EVM
Example
:CONF:EVM
3.6.8.2 Radio
Contains controls to select Radio Standard and settings.
Radio Std Detection
Enables automatic detection of the radio standard of a WLAN signal from DUT. The
auto detection can detect all WLAN family, except 802.11ah.
This function is available for Modulation Analysis and Spectral Flatness
measurements. In other measurements, when Auto is selected, error message “-221
Setting conflict, Auto detection is not available for current measurement” appears.
When Radio Std Detection is Auto, Radio Std is grayed-out.
When set to Man, the radio standard is determined by "Radio Std" on page 1835.
The default settings is Manual.
Remote
Command
[:SENSe]:RADio:STANdard[:WLAN]:DETect:AUTO OFF | ON | 0 | 1
[:SENSe]:RADio:STANdard[:WLAN]:DETect:AUTO?
Example
:RAD:STAN:DET:AUTO ON
:RAD:STAN:DET:AUTO?
Notes Auto detection can detect all WLAN family, except 802.11ah
The auto detection function is available for Modulation Analysis and Spectral Flatness measurements. In
other measurements, if Auto is selected, error message “-221 Setting conflict, Auto detection is not
available for current measurement” appears
979 WLAN Mode User's &Programmer's Reference
To Next Page
Loading...
