3 WLAN Mode
3.8 Power vs Time Measurement
increment the Z value. Then continue incrementing the X position in the same
manner as before.
Note that for symbol tables, which have no axes, incrementing the X position in
points moves the marker consecutively through all table entries.
Remote
Command
:CALCulate:PVTime:MARKer[1]|2|...|12[:X]:POSition <real>
:CALCulate:PVTime:MARKer[1]|2|...|12[:X]:POSition?
Example
:CALC:PVTime:MARK:POS 25
:CALC:PVTime:MARK:POS?
Notes When a marker mode is changed from off to any other mode, the X position is set to mid-screen.
Preset None until marker is turned on.
State Saved Yes
Min Depends on trace data
Max Depends on trace data
Marker X Unit can be queried via SCPI.
Remote Command
:CALCulate:PVTime:MARKer[1]|2|...|12:X:UNIT?
Example
:CALC:PVTime:MARK:X:UNIT?
Notes Query Only
Coupling of Delta and Reference markers
The following coupling rules apply from the front panel and also if the equivalent
SCPI commands are sent.
Pressing the Delta key causes the selected marker to become a delta marker if it is
not already. Also, the selected marker's reference is affected as follows:
–
If the reference marker was off, it is turned on as a fixed marker.
–
The reference marker is moved to the trace of the selected marker and set to the
same position as the selected marker.
–
If the delta marker has a marker function turned on, the reference marker takes
on the same function (with the same band limits).
Exception: Pressing Delta when the selected marker's mode is not yet Delta does no
t move or change a reference marker that is already turned on (Normal, or Delta)
and on the same trace as the selected marker. It merely changes the selected
marker's mode to Delta and shows the current offset between it and the reference. If
you press Delta again (when the selected marker is already in Delta mode) then the
reference is moved and modified as described above.
WLAN Mode User's &Programmer's Reference 1374
To Next Page
Loading...
