Table Of Contents
Select Highlighted Analyzer 1079
Release Highlighted Analyzer 1080
Release All (Remote Command Only) 1081
Delete Highlighted Analyzer 1081
Delete All 1081
Query Analyzer Information (Remote Command Only) 1082
Query All Analyzer IP Addresses (Remote Query Only) 1082
Query remote analyzer MIMO capability (Remote Query Only) 1082
3.6.8.11 Tx Beam Forming Type (Remote Command Only) 1083
3.6.8.12 MIMO Tx Channel (Remote Command Only) 1083
3.6.8.13 Enable MAC Header Decoding (Remote Command Only) 1084
3.6.8.14 Fast Power Calibration State (Remote Command Only) 1084
3.6.9 Sweep 1084
3.6.9.1 Sweep/Control 1085
Sweep/Measure 1085
Restart 1087
Pause/Resume 1089
3.6.9.2 X Scale 1090
Ref Value 1090
Scale/Div 1092
Ref Position 1094
Auto Scaling 1095
3.6.9.3 Recording 1095
3.6.9.4 Playback 1096
Playback Mode 1097
Playback Start 1098
Playback Stop 1099
Step Forward 1100
Sample Rate 1100
3.6.10 Trace 1100
3.6.10.1 Settings 1101
Trace Smoothing 1101
3.7 WLAN MIMO Modulation Analysis Measurement 1102
3.7.1 WLAN MIMO Modulation Analysis Measurement Commands 1103
3.7.2 Views 1129
3.7.2.1 Stream IQ Polar 1132
3.7.2.2 Burst & Signal Info 1133
3.7.2.3 User Information Summary (11ax) 1133
3.7.2.4 EVM vs. Carrier 1133
3.7.2.5 EVM vs. Symbol 1133
WLAN Mode User's &Programmer's Reference 29
To Next Page